Equipment Is designed for performing Exclusive / Combi-functional units.

• Cleaning
• Drying
• Combo-Unit (Both cleaning and drying)
• Filter Integrity Testing

Equipment is available in following variants

• Basic Model (Pre-Loaded Program).
• With HMI & SCADA
• With IPC.

Equipment is suitable for accommodating both type of Filters

• Flange
• Box

Is designed to handle pre-filters exposed to both

• Atmospheric dust
• Water soluble bulk powder deposit.

No. of Filters that can be cleaned / tested (at a time)* will be

• 1 / 2 / 4 Filters

* Conditions Apply:
1) Depends on the Equipment Size, decided in line with  room layout, and
2) Considered Minm. and Maxm. Size of Filters

Equipment is suitable for testing Pre-Filters of following Size

• Minm. Filter Size: 305 * 305 * 50 mm.
• Maxm. Filter Size: 610 * 610 * 305 mm.

No. of Filters cleaned (i.e. Output) per hour.

• 4 to 8 Filters per hour (For 610 * 610 *305 Filter Size)

Cleaning and Drying Cycle is as follows

• Air Clean (with Compressed Air)
• Water Wash
• Hot Air Drying with Blower (Either With Heater / Plant Steam, as applicable)

Utilities Required:

• Electrical Power: 3 Phase, 415 ± 10 Volts, 50 ± 5 Hz.
• Compressed Air: 6 Bar.
• Soft Water: 60 LPM at 1 Bar
• Plant Steam: 2kg/min @ 1 to 1.5 Bar.

Optional supply

• Dust Collection Unit
• Scrubber Can be customized to suite Injectable, OSD, API, Bulk and Biologics manufacturing  units.

Sequence of Operation:

• Filters are loaded over and secured to the Filter Holding  frame.
• Doors are closed and respective push button / soft key  (As applicable) is pressed for starting the Cycle.
• Post Air Clean, Water Wash is initiated. And is followed by  Hot Air Drying.
• Before the filters are unloaded from the  doors at the Unloading end.